1. Polyacrylamide can't be put directlr into sewage, so dissolve in water before using the PAM.
2. The dissolved water should be clean water, and without heating, but the temperature can't be cold. The temperature is higher
than five degress Celsius. Otherwise it will be dissolve very slowly. Temperature above 40 degrees Celsius affect the use effect.
3. Notice: Don't use strong acid, strong base, high salt water preparation.
4. The ratio range is recommended to be between 0.1% and 0.3%. For example, 1 liter of water with 1~3g of agents.
5. If because of other reasons, the dispersion is not good, we suggest that you mix a little more sparse.
6. The water is warmer in Summer. Cationic, Anionic Polyacrylamide should be strict for about 1 hour. Nonionic Polyacrylamide
should be strict for about 2 hours.
7. The water is cold in Winter, Cationic, Anionic PAM should be strict for about one and a half hours. Nonionic
Polyacrylamide should be strict for about 3 hours.
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
SUBMIT
More information facilitates better communication.
Mr.
- Mr.
- Mrs.
OK
Submitted successfully!
We will call you back soon!
OK
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
SUBMIT